Reference Guide

ipv6 unicast
soft [in | out]
(OPTIONAL) Enter the keywords ipv6 multicast soft
[in | out] to set options within the specified IPv6 address
family.
soft (OPTIONAL) Enter the keyword soft to configure and
activate policies without resetting the BGP TCP session, that
is, BGP Soft Reconfiguration.
NOTE: If you enter clear ip bgp ip6-address
soft
, both inbound and outbound policies are reset.
in (OPTIONAL) Enter the keyword in to activate only inbound
policies.
out (OPTIONAL) Enter the keyword out to activate only
outbound policies.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
clear ip bgp as-number
Reset BGP sessions. The soft parameter (BGP Soft Reconfiguration) clears the policies without resetting
the TCP connection.
Syntax
clear ip bgp as-number [flap-statistics | ipv4 {multicast
{flap-statistics | soft {in | out}} | unicast {flap-statistics
| soft {in | out}} | ipv6 unicast {flap-statistics | soft {in |
out}| soft [in | out]
Parameters
as-number Enter an autonomous system (AS) number to reset neighbors
belonging to that AS. If used without a qualifier, the keyword
resets all neighbors belonging to that AS. The range is from 1
to 65535.
IPv6 Border Gateway Protocol (IPv6 BGP)
1085