Reference Guide

Parameters
ipv6-address Enter the IPv6 address of the target BGP neighbor.
direction {both
| rx | tx}
Enter the keyword direction and a direction — either rx
for inbound, tx for outbound, or both.
Defaults Not configured.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Related
Commands
capture bgp-pdu max-buffer-size – enables route reflection between the route
reflector and the clients.
show capture bgp-pdu neighbor – configures a route reflector and clients.
capture bgp-pdu neighbor – enables capture of an IPv4 BGP neighbor packet.
clear ip bgp * (asterisk)
Reset all BGP sessions in the specified category. The soft parameter (BGP Soft Reconfiguration) clears the
policies without resetting the TCP connection.
Syntax
clear ip bgp * [ipv4 multicast soft [in | out] | ipv6 unicast
soft [in | out] | soft [in | out]]
Parameters
* Enter an asterisk ( * ) to reset all BGP sessions.
ipv4 multicast
soft [in | out]
(OPTIONAL) Enter the keywords ipv4 multicast soft
[in | out] to set options within the specified IPv4 address
family.
1084
IPv6 Border Gateway Protocol (IPv6 BGP)