Reference Guide

Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
This command is a knob to disable BGP next-hop resolution using BGP learned
routes. During the next-hop resolution, only the first route that the next-hop
resolves through is verified for the route’s protocol source and is checked if the
route is learned from BGP or not.
For this command to take effect and to keep the BGP database consistent, you
need the clear ip bgp command. Execute the clear ip bgp command right
after executing this command.
Related
Commands
capture bgp-pdu max-buffer-size
bgp regex-eval-optz-disable
Disables the Regex Performance engine that optimizes complex regular expression with BGP.
Syntax
bgp regex-eval-optz-disable
To re-enable optimization engine, use the no bgp regex-eval-optz-disable
command.
Defaults Enabled.
Command
Modes
ROUTER BGP (conf-router_bgp)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
BGP uses regular expressions (regex) to filter route information. In particular, the
use of regular expressions to filter routes based on AS-PATHs and communities is
1080
IPv6 Border Gateway Protocol (IPv6 BGP)