Reference Guide

half-life period expires. The range is from 1 to 45. The default
is 15 minutes.
reuse (OPTIONAL) Enter a number as the reuse value, which is
compared to the flapping route’s Penalty value. If the Penalty
value is less than the reuse value, the flapping route is once
again advertised (or no longer suppressed). The range is from
1 to 20000. The default is 750.
suppress (OPTIONAL) Enter a number as the suppress value, which is
compared to the flapping route’s Penalty value. If the Penalty
value is greater than the suppress value, the flapping route is
no longer advertised (that is, it is suppressed). The range is
from 1 to 20000. The default is 2000.
max-suppress-
time
(OPTIONAL) Enter the maximum number of minutes a route
can be suppressed. The default is four times the half-life
value. The range is from 1 to 255. The default is 60 minutes.
route-map
map-name
(OPTIONAL) Enter the keywords route-map then the name
of a configured route map. Only match commands in the
configured route map are supported.
Defaults Disabled.
Command
Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
If you enter bgp dampening, the default values for half-life, reuse,
suppress, and max-suppress-time are applied. The parameters are position-
dependent; therefore, if you configure one parameter, you must configure the
parameters in the order they appear in the command.
Related
Commands
show ip bgp ipv6 unicast dampened-paths – views the BGP paths.
IPv6 Border Gateway Protocol (IPv6 BGP)
1073