Reference Guide

To remove bgp confederation peers, use the no bgp confederation peer
command.
Parameters
as-number Enter the AS number. The range is 1 to 65535.
...as-number (OPTIONAL) Enter up to 16 confederation numbers. The
range is from 1 to 65535.
Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
The Autonomous Systems configured in this command are visible to the EBGP
neighbors. Each Autonomous System is fully meshed and contains a few
connections to other Autonomous Systems.
After specifying autonomous systems numbers for the BGP confederation, recycle
the peers to update their configuration.
Related
Commands
bgp confederation identifier – configures a confederation ID.
bgp dampening
Enable BGP route dampening and configure the dampening parameters.
Syntax
bgp dampening [half-life reuse suppress max-suppress-time]
[route-map map-name]
Parameters
half-life (OPTIONAL) Enter the number of minutes after which the
Penalty is decreased. After the router assigns a Penalty of
1024 to a route, the Penalty is decreased by half, after the
1072
IPv6 Border Gateway Protocol (IPv6 BGP)