Reference Guide

bgp confederation identifier
Configure an identifier for a BGP confederation.
Syntax
bgp confederation identifier as-number
To delete a BGP confederation identifier, use the no bgp confederation
identifier as-number command.
Parameters
as-number Enter the AS number. The range is from 1 to 65535.
Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
The autonomous systems configured in this command are visible to the EBGP
neighbors. Each autonomous system is fully meshed and contains a few
connections to other autonomous systems. The next hop, MED, and local
preference information is preserved throughout the confederation.
The system accepts confederation EBGP peers without a LOCAL_PREF attribute.
The software sends AS_CONFED_SET and accepts AS_CONFED_SET and
AS_CONF_SEQ.
bgp confederation peers
Specify the autonomous systems (ASs) that belong to the BGP confederation.
Syntax
bgp confederation peers as-number [...as-number]
IPv6 Border Gateway Protocol (IPv6 BGP)
1071