Reference Guide

Usage
Information
The MED is a 4-byte unsigned integer value and the default behavior is to assume a
missing MED as 4294967295. This command causes a missing MED to be treated
as 0. During path selection, paths with a lower MED are preferred over those with a
higher MED.
bgp client-to-client reflection
Allows you to enable route reflection between clients in a cluster.
Syntax
bgp client-to-client reflection
To disable client-to-client reflection, use the no bgp client-to-client
reflection
command.
Defaults Enabled when a route reflector is configured.
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
Route reflection to clients is not necessary if all client routers are fully meshed.
Related
Commands
bgp cluster-id – assigns and ID to a BGP cluster with two or more route reflectors.
neighbor route-reflector-client – configures a route reflector and clients.
IPv6 Border Gateway Protocol (IPv6 BGP)
1069