Reference Guide

ipv6 nd dad attempts
To perform duplicate address detection (DAD) on the management interface, configure the number of
neighbor solicitation messages that are sent.
Syntax
ipv6 nd dad attempts {number of attempts}
To restore the default value, use the no ipv6 nd dad attempts command.
Parameters
number of
attempts
Enter the number of attempts to be made to detect a
duplicate address. The range is from 0 to 15. Setting the
value to 0 disables DAD on the interface.
Default 3 attempts
Command
Modes
INTERFACE (management interface only)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
ipv6 nd prefix
Specify which IPv6 prefixes are included in Neighbor Advertisements.
Syntax
ipv6 nd prefix {ipv6-prefix | prefix-length | default} [no-
advertise] | [no-autoconfig] [no-rtr-address] [off-link]
[lifetime {valid | infinite} {preferred | infinite}]
Parameters
ipv6-prefix Enter an IPv6 prefix.
prefix-length Enter the prefix then the prefix length. The length range is
from 0 to 128.
default Enter the keyword default to set default parameters for all
prefixes.
1046
IPv6 Basics