Reference Guide

filters in the IPv6 ACL, the traffic is permitted instead of
dropped).
vlan range (OPTIONAL) Enter the keyword vlan followed by the VLAN
range in a comma separated format. The range is 1 to 4094.
Defaults Disabled.
Command
Modes
INTERFACE
Command
History
Version 9.0.2.0 Introduced on the S6000.
Version 8.4.2.1 Introduced on the S-Series.
Version 7.8.1.0 Introduced on the C-Series. Increased the name string to
accept up to 140 characters. Prior to version 7.8.1.0, names
are up to 16 characters long.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
You can assign an IPv6 access group to a physical, LAG, or VLAN interface context.
Example
Dell(conf-if-gi-9/0)#ipv6 access-group AclList1 in implicit-
permit vlan 10-20
Dell(conf-if-gi-9/0)#show config
!
interface GigabitEthernet 9/0
no ip address
ipv6 access-group AclList1 in implicit-permit Vlan 10-20
no shutdown
Dell(conf-if-gi-9/0)#
ipv6 control-plane egress-filter
Enable egress Layer 3 ACL lookup for IPv6 CPU traffic.
Syntax
ipv6 control-plane egress-filter
Defaults Not enabled.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1010
IPv6 Access Control Lists (IPv6 ACLs)