Users Guide

Te 3/10 Up 0 0 5 750 2500 20
Dell#
Related Commands
dampening — congures dampening on an interface.
show interfaces — displays information on a specic physical interface or virtual interface.
show interfaces congured — displays any interface with a non-default conguration.
show interfaces phy
Display auto-negotiation and link partner information.
S4820T
Syntax
show interfaces gigabitethernet slot/port phy
Parameters
tengigabitethernet Enter the keyword tengigabitethernet then the slot or port information.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the C-Series and S-Series.
6.5.4.0 Introduced on the E-Series.
Usage Information The following describes the show interfaces gigabitethernet command following example.
Mode Control Indicates if auto negotiation is enabled. If so, indicates the selected speed
and duplex.
Mode Status Displays auto negotiation fault information. When the interface completes auto
negotiation successfully, the autoNegComplete eld and the linkstatus eld
read “True.”
AutoNegotiation
Advertise
Displays the control words the local interface advertises during negotiation. Duplex
is either half or full. Asym- and Sym Pause is the types of ow control the local
interface supports.
AutoNegotiation
Remote Partner’s
Ability
Displays the control words the remote interface advertises during negotiation.
Duplex is either half or full. Asym- and Sym Pause is the types of ow control the
remote interface supports.
696
Interfaces