Reference Guide

924 | Stacking
www.dell.com | support.dell.com
In the following example, stack unit 1 will be the master management unit, stack unit 2 will be the standby
unit. The cables are connected to each unit.
Configure the stack groups on the units in the following order:
Configure the first stack group on unit 1:
stack-unit 1 stack-group 13
Configure the stack groups on unit 2:
stack-unit 2 stack-group 14
stack-unit 2 stack-group 15
Configure the stack groups on unit 3:
7 Reload the stack one unit at a time. Start with the
management unit, then the standby, followed by
each of the members in order of their assigned
stack number (or the position in the stack you
want each unit to take). Allow each unit to
completely boot, and verify that the unit is
detected by the stack manager, and then power
the next unit.
show system brief
EXEC Privilege
Step Task Command Syntax Command Mode