Reference Guide

-- Line card 0 --
Status : not present
Required Type : E48VB - 48-port GE 10/100/1000Base-T line card with RJ45
interfaces and PoE (CB)
Dell(conf)#int gig 0/0
Dell(conf-if-gi-0/0)#
Replacing a Line Card
If you are replacing a line card with a line card of the same type, you may replace the card without any
additional configuration.
If you are replacing a line card with a line card of a different type, remove the card and then remove the
existing line card configuration.
To remove the line card configuration, use the following command.
• Remove the card and then remove the existing line card configuration.
CONFIGURATION mode
no linecard
Example of Verifying Line Card Configuration After Clearing Mismatch Status
If you do not, Dell Networking OS reports a card mismatch (as shown in the following message) when
you insert the new card, and the installed line card has a card mismatch status.
%RPM0-P:CP %CHMGR-3-CARD_MISMATCH: Mismatch: line card 0 is type E48VB - type
E48TB required
To clear this line card mismatch status, bring the line card online, and specify the type of line card you
inserted, use the linecard command.
%RPM0-P:CP %CHMGR-5-CARDDETECTED: Line card 0 present
%RPM0-P:CP %CHMGR-3-CARD_MISMATCH: Mismatch: line card 0 is type E48VB - type
E48TB required
Dell#show linecard all
-- Line cards --
Slot Status NxtBoot ReqTyp CurTyp Version Ports
---------------------------------------------------------------------------
0 type mismatch online E48TB E48VB 7-5-1-71 48
[output omitted]
Dell(conf)#linecard 0 E48VB
Aug 6 14:25:22: %RPM0-P:CP %IFMGR-1-DEL_PORT: Removed port: Gi 0/0-47
Dell(conf)#Aug 6 14:25:24: %RPM0-P:CP %CHMGR-5-LINECARDUP: Line card 0 is up
Dell#show linecard all
-- Line cards --
Slot Status NxtBoot ReqTyp CurTyp Version Ports
---------------------------------------------------------------------------
0 online online E48VB E48VB 7-5-1-71 48
[output omitted]
392
High Availability (HA)