Reference Guide

• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from 1 to
4094.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 9.2(0.2) Introduced on the Z9000.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.12.0 Introduced on the S4810.
Usage
Information
The following describes the show isis traffic command shown in the following
example.
Item Description
Level-1/Level-2
Hellos (sent/rcvd)
Displays the number of Hello packets sent and received.
PTP Hellos (sent/
rcvd)
Displays the number of point-to-point Hellos sent and received.
Level-1/Level-2 LSPs
sourced (new/
refresh)
Displays the number of new and refreshed LSPs.
Level-1/Level-2 LSPs
flooded (sent/rcvd)
Displays the number of flooded LSPs sent and received.
Level-1/Level-2 LSPs
CSNPs (sent/ rcvd)
Displays the number of CSNP LSPs sent and received.
Level-1/Level-2 LSPs
PSNPs (sent/ rcvd)
Displays the number of PSNP LPSs sent and received.
Level-1/Level-2 DR
Elections
Displays the number of times designated router elections ran.
Level-1/Level-2 SPF
Calculations
Displays the number of shortest path first calculations.
LSP checksum
errors received
Displays the number of checksum errors LSPs received.
LSP authentication
failures
Displays the number of LSP authentication failures.
811