Reference Guide

Related
Commands
clear ip bgp — resets BGP sessions.
neighbor peer-group (creating group) — creates a peer group.
show ip bgp peer-group — views BGP peers.
show ip bgp neighbors — views BGP neighbors configurations.
neighbor peer-group (creating group)
Allows you to create a peer group and assign it a name.
S4820T
Syntax
neighbor peer-group-name peer-group
To delete a peer group, use the no neighbor peer-group-name peer-group
command.
Parameters
peer-group-name Enter a text string up to 16 characters long as the name of the peer
group.
Defaults Not configured.
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
When you create a peer group, it is disabled (Shut mode).
Related
Commands
neighbor peer-group (assigning peers) — assigns routers to a peer group.
neighbor remote-as — assigns a indirectly connected AS to a neighbor or peer group.
neighbor shutdown — disables a peer or peer group.
neighbor peer-group passive
Enable passive peering on a BGP peer group, that is, the peer group does not send an OPEN message, but responds to
one.
S4820T
Syntax
neighbor peer-group-name peer-group passive [limit sessions]
324