Reference Guide

match ip address
To match routes based on IP addresses specified in an access list, configure a filter.
S4820T
Syntax
match ip address prefix-list-name
To delete a match, use the no match ip address prefix-list-name command.
Parameters
prefix-list-name Enter the name of configured prefix list, up to 140 characters.
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Increased the name string to accept up to 140 characters. Prior to
7.8.1.0, names are up to 16 characters long.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Related
Commands
match interface — redistributes routes that match the next-hop interface.
match ip next-hop — redistributes routes that match the next-hop IP address.
match ip route-source — redistributes routes that match routes advertised by other routers.
match metric — redistributes routes that match a specific metric.
match route-type — redistributes routes that match a route type.
match tag — redistributes routes that match a specific tag.
match ip next-hop
To match based on the next-hop IP addresses specified in an IP access list or IP prefix list, configure a filter.
S4820T
Syntax
match ip next-hop {prefix-list prefix-list-name}
To delete a match, use the no match ip next-hop {prefix-list prefix-
list-name} command.
242