Reference Guide

• For a VLAN interface, enter the keyword vlan then the
VLAN ID. The VLAN ID range is from 1 to 4094.
vrrp-id (OPTIONAL) Enter a number from 1 to 255 as the VRRP group ID.
all Enter the keyword all to enable debugging of all VRRP groups.
bfd Enter the keyword bfd to enable debugging of VRRP BFD
interactions.
database Enter the keyword database to enable debugging of configuration
changes.
interface Enter the keyword interface to enable debugging of interface
state changes..
ipv6 Enter the keyword ipv6 to enable debugging for IPv6.
packets Enter the keyword packets to enable debugging of VRRP control
packets.
state Enter the keyword state to enable debugging of VRRP state
changes.
timer Enter the keyword timer to enable debugging of the VRRP timer.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Usage
Information
If no options are specified, debug is active on all interfaces and all VRRP groups.
description
Configure a short text string describing the VRRP group.
S4820T
Syntax
description text
To delete a VRRP group description, use the no description command.
Parameters
text Enter a text string up to 80 characters long.
1422