Reference Guide

Parameters
number Assign an event number in integer format from 1 to 65535. The number
value must be unique in the RMON event table.
log (OPTIONAL) Enter the keyword log to generate an RMON log entry.
The log entry is triggered and sets the eventType in the RMON MIB to
log or log-and-trap. The default is No log.
trap community (OPTIONAL) Enter the keyword trap then an SNMP community
string to configure the eventType setting in the RMON MIB. This
keyword sets either snmp-trap or log-and-trap. The default is
public.
description string (OPTIONAL) Enter the keyword description then a string
describing the event.
owner name (OPTIONAL) Enter the keyword owner then the name of the owner of
this event.
Defaults As noted in the Parameters section.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.1.1.0 Introduced on the E-Series.
rmon hc-alarm
Set an alarm on any MIB object.
S4820T
Syntax
rmon hc-alarm number variable interval {delta | absolute}
rising-threshold value event-number falling-threshold value
event-number [owner string]
To disable the alarm, use the no rmon hc-alarm number command.
Parameters
number Enter the alarm integer number from 1 to 65535. The value must be
unique in the RMON alarm table.
1167