Reference Guide

df-bit (IPv4 only) Enter Y or N for the “don't fragment” bit in IPv4 header.
• N: Do not set the “don't fragment” bit.
• Y: Do set “don't fragment” bit
Default is No.
validate-reply (IPv4 only) Enter Y or N for reply validation.
• N: Do not validate reply data.
• Y: Do validate reply data.
Default is No.
outgoing-
interface
(IPv6 link-local address) Enter the outgoing interface for ping packets
to a destination link-local address.
pattern pattern (IPv4 only) Enter the IPv4 data pattern. Range: 0-FFFF. Default:
0xABCD.
sweep-min-size Enter the minimum size of datagram in sweep range. The range is
from 52 to 15359 bytes.
sweep-max-size Enter the maximum size of datagram in sweep range. The range is
from 53 to 15359 bytes.
sweep-interval Enter the incremental value for sweep size. The range is from 1 to
15308 seconds.
ointerface (IPv4 only) Enter the outgoing interface for multicast packets. Enter
the IP address in A.B.C.D format.
• For a Port Channel, enter the keyword port-channel then
a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the
relevant FTOS Command Line Reference Guide .
The following is a list of the FTOS version history for this command.
Version 8.3.19.0
Introduced on the S4820T.
Added support for the outgoing-interface option for link-local
IPv6 addressing on the S4820T.
102