Users Guide
If you are conguring only one area in your network, you do not need to run both Level 1 and Level 2 routing
algorithms. You can congure the IS type as Level 1.
log-adjacency-changes
Generate a log messages for adjacency state changes.
Syntax
log-adjacency-changes
To disable this function, use the no log-adjacency-changes command.
Defaults Adjacency changes are not logged.
Command Modes ROUTER ISIS
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
Usage Information This command allows you to monitor adjacency state changes, which are useful when you monitor large
networks. Messages are logged in the system’s error message facility.
lsp-gen-interval
Set the minimum interval between successive generations of link-state packets (LSPs).
Syntax
lsp-gen-interval [level-l | level-2] interval seconds
[initial_wait_interval seconds [second_wait_interval seconds]]
To restore default values, use the no lsp-gen-interval [level-l | level-2] interval
seconds [initial_wait_interval seconds [second_wait_interval seconds]]
command.
Parameters
level-l (OPTIONAL) Enter the keywords level-1 to apply the conguration to
generation of Level-1 LSPs.
level-2 (OPTIONAL) Enter the keywords level-2 to apply the conguration to
generation of Level-2 LSPs.
880
Intermediate System to Intermediate System (IS-IS)