Users Guide

isis network point-to-point
Enable the software to treat a broadcast interface as a point-to-point interface.
Syntax
isis network point-to-point
To disable the feature, use the no isis network point-to-point command.
Defaults Not enabled.
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
isis password
Congure an authentication password for an interface.
Syntax
isis password [hmac-md5] password [level-1 | level-2]
To delete a password, use the no isis password [password] [level-1 | level-2]
command.
Parameters
encryption-type (OPTIONAL) Enter 7 to encrypt the password using DES.
hmac-md5 (OPTIONAL) Enter the keywords hmac-md5 to encrypt the password using MD5.
password Assign the interface authentication password.
level-1 (OPTIONAL) Independently congures the authentication password for Level 1.
The router acts as a station router for Level 1 routing. This setting is the default.
level-2 (OPTIONAL) Independently congures the authentication password for Level 2.
The router acts as an area router for Level 2 routing.
Defaults No default password. level-1 (if not otherwise specied).
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
Intermediate System to Intermediate System (IS-IS)
877