Users Guide

Version Description
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.9.1.0 Introduced VRF on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage Information The following describes the show ip route all command in the following example.
Field Description
(undened) Identies the type of route:
• C = connected
• S = static
• R = RIP
• B = BGP
• IN = internal BGP
• EX = external BGP
• LO = Locally Originated
• O = OSPF
• IA = OSPF inter area
• N1 = OSPF NSSA external type 1
• N2 = OSPF NSSA external type 2
• E1 = OSPF external type 1
• E2 = OSPF external type 2
• i = IS-IS
• L1 = IS-IS level-1
• L2 = IS-IS level-2
• IA = IS-IS inter-area
• * = candidate default
• > = non-active route
• + = summary routes
Destination
Identies the route’s destination IP address
Gateway Identies whether the route is directly connected and on which interface the route is
congured.
Dist/Metric Identies if the route has a specied distance or metric.
Last Change Identies when the route was last changed or congured.
The weight for weighted ECMP route calculations is displayed for each path in the route in show ip route
command. The ECMP weight is displayed only if weighted ECMP is enabled using the ip ecmp weighted
command is enabled.
796
IPv4 Routing