Users Guide

• Routing information protocol (RIP) is not supported with the UDP Broadcast feature.
• If you congure this feature on an interface using the ip udp-helper udp-port command, the ip directed-
broadcast command becomes ineective on that interface.
• The existing show interface command has been modied to display the congured broadcast address.
debug ip udp-helper
Enable UDP debug and display the debug information on a console.
S4810
Syntax
debug ip udp-helper
To disable debug information, use the no debug ip udp-helper command.
Defaults Debug disabled.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Pre-version 8.3.7.0 Introduced on the E-Series ExaScale.
Example
Dell#debug ip udp-helper
UDP helper debugging is on
01:20:22: Pkt rcvd on Gi 5/0 with IP DA (0xffffffff) will be sent on Gi
5/1 Gi 5/2
Vlan 3
01:44:54: Pkt rcvd on Gi 7/0 is handed over for DHCP processing.
Related Commands
ip udp-broadcast-address — congures a UDP IP address for broadcast.
ip udp-helper udp-port — enables the UDP broadcast feature on an interface.
show ip udp-helper — displays the congured UDP helper(s) on all interfaces.
ip udp-broadcast-address
Congure an IP UDP address for broadcast.
Syntax
ip udp-broadcast-address address
To delete the conguration, use the no ip udp-broadcast-address address command.
726
Interfaces