Users Guide

ipv6 unknown-unicast
Disable soft forwarding of unknown IPv6 destination packets.
S4810
Syntax
[no] ipv6 unknown-unicast
Defaults Soft forwarding is enabled.
Command Modes CONFIGURATION
Command History
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
Usage Information All the default catch-all entries in the longest prex match (LPM) table collect and transmit all unresolved
IPv6 packets to the CPU, even if they are destined for unknown destinations.
show cpu-queue rate cp
Display the rates for each CPU queue.
S4810
Syntax
show cpu-queue rate cp
Defaults Not congured.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Introduced on the S4810.
Usage Information
This command applies the service-policy based on the type of protocol dened in the ACL rules.
Create ACL and QoS policies prior to enabling this command.
Example
Dell#show cpu-queue rate cp
Service-Queue Rate (PPS) Burst ()
-------------- ----------- -----------
Q0 1300 512
Control Plane Policing (CoPP)
461