Users Guide

Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant FTOS
Command Line Reference Guide.
The following is a list of the FTOS version history for this command.
Version Description
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.10.0 Introduced on the S4810.
neighbor soft-reconguration inbound
Enable a BGP soft-reconguration and start storing updates for inbound IPv6 unicast routes.
S4810
Syntax
neighbor {ipv4-address | ipv6-address | peer-group-name} soft-
reconfiguration inbound
Parameters
ipv4-address | ipv6-
address
Enter the IP address of the neighbor for which you want to start storing inbound
routing updates.
peer-group-name Enter the name of the peer group for which you want to start storing inbound
routing updates.
Defaults Disabled.
Command Modes ROUTER BGPv6 ADDRESS FAMILY (conf-router_bgpv6_af)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
8.4.1.0 Added support for IPv4 multicast and IPv4 unicast address families.
8.3.19.0 Introduced on the S4820T.
7.8.1.0 Introduced on the S4810.
7.7.1.0 Introduced on the C-Series.
7.4.1.0 Introduced
Usage Information This command enables soft-reconguration for the specied BGP neighbor. BGP stores all updates for
inbound IPv6 unicast routes the neighbor receives but does not reset the peer-session.
CAUTION: Inbound update storage is a memory-intensive operation. The entire BGP update
database from the neighbor is stored in memory regardless of the inbound policy results applied on
the neighbor.
446
Border Gateway Protocol