Users Guide

debug ip bgp ipv6 unicast soft-reconguration
Enable soft-reconguration debugging for IPv6 unicast routes.
S4810
Syntax
debug ip bgp [ipv4-address | ipv6-address | peer-group-name] ipv6 unicast
soft-reconfiguration
To disable debugging, use the no debug ip bgp [ipv4-address | ipv6-address | peer-
group-name] ipv6 unicast soft-reconfiguration command.
Parameters
ipv4-address | ipv6-
address
Enter the IP address of the neighbor on which you want to enable soft-
reconguration debugging.
peer-group-name Enter the name of the peer group on which you want to enable soft-
reconguration debugging.
ipv6 unicast Debug soft reconguration for IPv6 unicast routes.
Defaults Disabled.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
8.3.19.0 Introduced on the S4820T.
8.4.1.0 Added support for IPv4 multicast and IPv6 unicast routes.
7.8.1.0 Introduced on the S4810.
7.7.1.0 Introduced on the C-Series.
7.2.1.0 Introduced on the E-Series TeraScale.
Usage Information
This command turns on BGP soft-reconguration inbound debugging for IPv6 unicast routes. If no neighbor
is specied, debug is turned on for all neighbors.
ipv6 prex-list
Congure an IPv6 prex list.
S4810
Syntax
ipv6 prefix-list prefix-list name
Parameters
prex-list name Enter the name of the prex list.
NOTE: There is a 140-character limit for prex list names.
Defaults none
Border Gateway Protocol
445