Users Guide

Dell#
Related Commands show ip bgp — views the current BGP routing table.
show ip bgp next-hop
View all next hops (using learned routes only) with current reachability and ap status. This command only displays one path, even if
the next hop is reachable by multiple paths.
S4810
Syntax
show ip bgp [vrf vrf-name] next-hop
Parameters
vrf vrf-name Enter the keyword vrf followed by the name of the VRF to view all next hops
corresponding to that VRF.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.4.(0.0) Added support for VRF.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
The following describes the show ip bgp next-hop command shown in the following example.
Field Description
Next-hop Displays the next-hop IP address.
Via Displays the IP address and interface used to reach the next hop.
RefCount Displays the number of BGP routes using this next hop.
Cost Displays the cost associated with using this next hop.
Flaps Displays the number of times the next hop has apped.
Time Elapsed Displays the time elapsed since the next hop was learned. If the route is down, this
eld displays time elapsed since the route went down.
426
Border Gateway Protocol