Users Guide

Related Commands
show debugging — views the enabled debugging operations.
show ip bgp ap-statistics — views the BGP ap statistics.
undebug all — disables all debugging operations.
clear ip bgp peer-group
Reset a peer-group’s BGP sessions.
S4810
Syntax
clear ip bgp [vrf vrf-name] peer-group peer-group-name [ipv4 [multicast |
unicast] | ipv6 unicast] [soft {in | out}]
Parameters
vrf vrf-name Enter the keyword vrf and then the name of the VRF to reset the peer group
corresponding to that VRF.
NOTE: You can use this attribute on a specic VRF to remove history
routes corresponding to that VRF. You can also use this attribute to return
the suppressed routes corresponding to a specic VRF to an active state.
peer-group-name Enter the peer group name to reset the BGP sessions within that peer group.
ipv4 multicast (OPTIONAL) Enter the keyword ipv4 followed by the keyword multicast to
reset ipv4 multicast routes.
ipv4 unicast (OPTIONAL) Enter the keyword ipv4 followed by the keyword unicast to reset
ipv4 unicast routes.
ipv6 unicast (OPTIONAL) Enter the keyword ipv6 followed by the keyword unicast to reset
ipv6 unicast routes.
soft (OPTIONAL) Enter the keyword soft to reset soft conguration.
in Enter the keyword in to re-congure soft inbound updates.
out Enter the keyword out to re-congure soft outbound updates.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added the ipv4 multicast and ipv6 unicast parameters.
9.4.(0.0) Added support for VRF.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
362
Border Gateway Protocol