Users Guide

Example
Dell(conf)#ip community-list TestComList
Dell(config-community-list)#
show ip community-lists
Display congured IP community lists in alphabetic order.
Syntax
show ip community-lists [name]
Parameters
name (OPTIONAL) Enter the name of the standard or extended IP community list, up to
140 characters.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Increased the name string to accept up to 140 characters. Prior to 7.8.1.0, names
are up to 16 characters long.
pre-Version 6.1.1.0 Introduced on the E-Series.
Example
Dell#show ip community-lists
ip community-list ABC
permit local-AS
deny no-advertise
permit no-export
Dell#
deny (for Standard IP ACLs)
To drop packets with a certain IP address, congure a lter.
Syntax
deny {source | any | host {ip-address}}[count [byte]] [dscp value] [order]
[fragments] [log [interval minutes] [threshold-in-msgs [count]] [monitor]
To remove this lter, you have two choices:
• Use the no seq sequence-number command if you know the lter’s sequence number.
•
Use the no deny {source [mask] | any | host ip-address} command.
Parameters
log (OPTIONAL) Enter the keyword log to enable the triggering of ACL log messages.
272
Access Control Lists (ACL)