Users Guide

• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
• For a VLAN interface, enter the keyword vlan then the VLAN ID. The VLAN
ID range is from 1 to 4094.
interface Enter the keyword interface to enable debugging of interface state changes.
ipv6 Enter the keyword ipv6 to enable debugging for IPv6.
packets Enter the keyword packets to enable debugging of VRRP control packets.
state Enter the keyword state to enable debugging of VRRP state changes.
timer Enter the keyword timer to enable debugging of the VRRP timer.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage Information If you do not specify an option, debug is active on all interfaces and all VRRP groups.
description
Congure a short text string describing the VRRP group.
Syntax
description text
To delete a VRRP group description, use the no description command.
Parameters
text Enter a text string up to 80 characters long.
Defaults Not enabled.
Command Modes VRRP
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1574
Virtual Router Redundancy Protocol (VRRP)