Users Guide

passive-interface 0 TenGigabitEthernet 1/1
Dell(conf-router_ospf)#
show ip ospf
Display information on the OSPF process congured on the switch.
S4810
Syntax
show ip ospf [process-id | vrf vrf name]
Parameters
process-id Enter the OSPF Process ID to show a specic process. If no Process ID is entered,
command applies only to the rst OSPF process.
vrf vrf name Show only the OSPF information tied to the VRF process.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.4.(0.0) Added support for VRF.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Added output for LSA throttling timers.
8.3.7.0 Introduced on the S4810.
7.9.1.0 Added support for VRF.
7.8.1.0 Added support of Multi-Process OSPF.
7.8.1.0 Added the process-id option, in support of Multi-Process OSPF.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre- 6.1.1.1 Introduced on the E-Series.
Usage Information If you delete all the network area commands for Area 0, the show ip ospf command output does not list
Area 0.
The following describes the show ip ospf command shown in the following example.
Line Beginning
with
Description
“Routing Process...” Displays the OSPF process ID and the IP address associated with the process ID.
Open Shortest Path First (OSPFv2 and OSPFv3)
1081