Users Guide

Version Description
9.1(0.0) Added support for OSPFv3 on the S4810 and Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.9.1.0 Added support for VRF.
7.8.1.0 Added support for Multi-Process OSPF.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre- 6.1.1.1 Introduced on the E-Series.
Usage Information You must have an IP address assigned to an interface to enter ROUTER OSPF mode and congure OSPF.
After the OSPF process and the VRF are tied together, you cannot use the OSPF Process ID again in the
system.
Example
Dell(conf)#router ospf 2
Dell(conf-router_ospf)#
show cong
Display the non-default values in the current OSPF conguration.
S4810
Syntax
show config
Command Modes ROUTER OSPF
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre- 6.1.1.1 Introduced on the E-Series.
Example
Dell(conf-router_ospf)#show config
!
router ospf 3
1080
Open Shortest Path First (OSPFv2 and OSPFv3)