Users Guide

ip ospf priority
To determine the designated router for the OSPF network, set the priority of the interface.
S4810
Syntax
ip ospf priority number
To return to the default setting, use the no ip ospf priority command.
Parameters
number Enter a number as the priority. The range is from 0 to 255. The default is 1.
Defaults 1
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre- 6.1.1.1 Introduced on the E-Series.
Usage Information
Setting a priority of 0 makes the router ineligible for election as a designated router or backup designated
router.
Use this command for interfaces connected to multi-access networks, not point-to-point networks.
ip ospf retransmit-interval
Set the retransmission time between lost link state advertisements (LSAs) for adjacencies belonging to the interface.
S4810
Syntax
ip ospf retransmit-interval seconds
To return to the default values, use the no ip ospf retransmit-interval command.
Parameters
seconds Enter the number of seconds as the interval between retransmission. The range is
from 1 to 3600. The default is 5 seconds.
Open Shortest Path First (OSPFv2 and OSPFv3)
1069