Reference Guide

iscsi profile-compellant
Configure the auto-detection of Dell Compellent arrays on a port.
S4810
Syntax
iscsi profile-compellent
Defaults Dell Compellent disk arrays are not detected.
Command Modes INTERFACE
Command History
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module.
iscsi target port
Configure the iSCSI target ports and optionally, the IP addresses on which iSCSI communication is monitored.
S4810
Syntax
iscsi target port [tcp-port-2...tcp-port-16]ip-address [ip-
address]
To remove the configured iSCSI target ports or IP addresses, use the no iscsi target
port command.
Parameters
tcp-
port-2...tcpport-
16
Enter the tcp-port number of the iSCSI target ports. The tcp-port-
n
is the TCP port number or a list of TCP port numbers on which the
iSCSI target listens to requests. Separate port numbers with a
comma. The default is 860, 3260.
ip-address
(Optional)
Enter the ip-address that the iSCSI monitors. The ip-address specifies
the IP address of the iSCSI target.
Defaults 860, 3260
Command Modes CONFIGURATION
Command History
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module.
Usage
Information
You can configure up to 16 target TCP ports on the switch in one command or multiple
commands.
974