Reference Guide

set ipv6 next-hop
Configure a filter that specifies IPv6 address as the next hop.
C-Series, E-Series, S-Series
Syntax
set ipv6 next-hop ipv6-address
To delete the setting, use the no set ipv6 next-hop ipv6-address command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
Version 8.4.2.1 Introduced on the S-Series.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
The set ipv6 next-hop command is the only way to set an IPv6 Next-Hop.
show config
View the current IPv6 ACL configuration.
C-Series, E-Series, S-Series
Syntax
show config
Command Modes ACCESS-LIST
Command History
Version 8.4.2.1 Introduced on the S-Series.
Version 8.4.2.0 Introduced on the E-Series TeraScale.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Introduced on the C-Series.
Example
FTOS(conf-ipv6-acl)#show config
!
ipv6 access-list Acl1
seq 5 permit ipv6 1111::2222/127 host 3333::1111 log count
bytes
seq 10 permit icmp host 3333:: any mobile-advertisement log
seq 15 deny tcp any any rst
944