Reference Guide

resequence access-list
Re-assign sequence numbers to entries of an existing access-list.
C-Series, E-Series, S-Series
Syntax
resequence access-list {ipv4 | ipv6 | mac} {access-list-name
StartingSeqNum Step-to-Increment}
Parameters
ipv4 | ipv6 | mac Enter the keyword ipv4, ipv6 or mac to identify the access list
type to resequence.
access-list-name Enter the name of a configured IP access list, up to 140 characters.
Increased name string to accept up to 140 characters. Prior to
version 7.8.1.0, names are up to 16 characters long.
StartingSeqNum Enter the starting sequence number to resequence. The range is 0 to
4294967290.
Step-to-
Increment
Enter the step to increment the sequence number. The range is 1 to
4294967290.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.4.2.0 Introduced on the S-Series.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
When all sequence numbers have been exhausted, this feature permits re-assigning new
sequence number to entries of an existing access-list.
Related
Commands
resequence prefix-list ipv6 – resequences a prefix list.
resequence prefix-list ipv6
Re-assign sequence numbers to entries of an existing prefix list.
C-Series, E-Series, S-Series
Syntax
resequence prefix-list ipv6 {prefix-list-name StartingSeqNum
Step-to-increment
}
932