Reference Guide

(OPTIONAL) Enter an in or out parameter in conjunction
with the optional interface.
• For a VLAN, enter the keyword vlan followed by a number
from 1 to 4094.
brief (OPTIONAL) Enter the keyword brief to view a brief summary of the
interfaces and whether an IP address is assigned.
linecard slot-
number
(OPTIONAL) Enter the keyword linecard followed by the number
of the line card slot. For the C-Series, the range is 0-7. For the E-
Series, the range is 0 to 13 on a E1200/1200i, 0 to 6 on a E600/E600i,
and 0 to 5 on a E300.
NOTE: This keyword is not available on the S-Series.
configuration (OPTIONAL) Enter the keyword configuration to display the
physical interfaces with non-default configurations only.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.2 Supported on the E-Series ExaScale E600i.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
The following describes the show ip interface command shown in the Example below.
Lines Description
TenGigabitEthernet
0/0...
Displays the interface’s type, slot/port, and physical and line protocol
status.
Internet address... States whether an IP address is assigned to the interface. If an IP
address is assigned, that address is displayed.
IP MTU is... Displays IP MTU value.
Inbound access... Displays the name of the any configured incoming access list. If
none is configured, the phrase “not set” is displayed.
Proxy ARP... States whether proxy ARP is enabled on the interface.
Split horizon... States whether split horizon for RIP is enabled on the interface.
897