Reference Guide

Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 7.7.1.0 Added support for up to seven stack members.
Version 7.6.1.0 Introduced on the S-Series.
Usage
Information
The following describes the show ip fib stack-unit command shown in the Example
below.
Field Description
Destination Lists the destination IP address.
Gateway Displays either the word “direct” and an interface for a directly
connected route or the remote IP address to be used to forward the
traffic.
First-Hop Displays the first hop IP address.
Mac-Addr Displays the MAC address.
Port Displays the egress-port information.
VId Displays the VLAN ID. If no VLAN is assigned, zero (0) is listed.
EC Displays the number of ECMP paths.
Example
FTOS#show ip fib stack-unit 0
Destination Gateway First-Hop Mac-Addr
------------------------------------------------------
10.10.10.10/32 Direct, Nu 0 0.0.0.0 00:00:00:00:00:00
Port VId EC
-------------
BLK HOLE 0 0
FTOS>
Related
Commands
clear ip fib stack-unit – Clear FIB entries on a specified stack-unit.
show ip flow
Show how a Layer 3 packet is forwarded when it arrives at a particular interface.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show ip flow interface [vrf vrf instance] interface {source-ip
address destination-ip address} {protocol number [tcp | udp] |
icmp} {src-port number destination-port number}
Parameters
vrf instance E-Series Only: Show only the L3 flow as they apply to that VRF
process.
894