Reference Guide

Parameters
id Enter the stack-unit ID.
The unit ID range is 0 to 7 for S-Series.
pipe-number Enter the number of the Port-Pipe number. The S50n and S50V range
is 0 to 1. The S25N, S25P, and S25V range is 0 to 0.
ip-address mask
[longer-prefix]
(OPTIONAL) Enter the IP address and mask of a route to CAM entries
for that route only. Enter the keywords longer-prefixes to view
routes with a common prefix.
summary (OPTIONAL) Enter the keyword summary to view a table listing route
prefixes and the total number routes which can be entered in to CAM.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 7.7.1.0 Added support for up to seven stack members.
Version 7.6.1.0 Introduced on the S-Series.
Usage
Information
The following describes the show ip cam command shown in the Example below.
Field Description
Destination Displays the destination route of the index.
EC Displays the number of equal cost multipaths (ECMP) available for
the default route for non-Jumbo line cards. For Jumbo line cards,
displays 0,1 when ECMP is more than eight.
CG Displays 0.
V Displays a 1 if the entry is valid and a 0 otherwise.
C Displays the CPU bit. 1 indicates that a packet hitting this entry is
forwarded to the CP or RP2, depending on Egress port.
V Id Displays the VLAN ID. If the entry is 0, the entry is not part of a VLAN.
Mac Addr Displays the next-hop router’s MAC address.
Port Displays the egress interface. Use the second half of the entry to
determine the interface. For example, in the entry 17cl CP, the CP is
the pertinent portion.
• CP = control processor
• Gi = Gigabit Ethernet interface
• Te = 10 Gigabit Ethernet interface
Example
FTOS#show ip cam stack-unit 0 port-set 0 10.10.10.10/32 longer-
prefixes
890