Reference Guide

show ip cam linecard
View CAM entries for a port pipe on a line card.
C-Series, E-Series, S4810
Syntax
show ip cam linecard number port-set pipe-number [ip-address
mask [longer-prefixes] | index index-number | summary | vrf vrf
instance]
Parameters
number Enter the number of the line card. The range is 0 to 13 on a
E1200/1200i, 0 to 6 on a E600600i, and 0 to 5 on a E300.
pipe-number Enter the number of the line card’s port-pipe. The range is 0 to 1.
ip-address mask
[longer-prefix]
(OPTIONAL) Enter the IP address and mask of a route to CAM entries
for that route only. Enter the keyword longer-prefixes to view
routes with a common prefix.
index index-
number
(OPTIONAL) Enter the keyword index followed by the CAM index
number. The range depends on CAM size.
summary (OPTIONAL) Enter the keyword summary to view a table listing route
prefixes and the total number of routes that can be entered into the
CAM.
vrf instance (OPTIONAL) E-Series Only: Enter the keyword vrf followed by the
VRF instance name to show CAM information as it applies to that VRF
instance.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.2 Introduced on the E-Series ExaScale E600i.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.9.1.0 Introduced VRF on the E-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
The following describes the show ip cam command shown in the Example below.
Field
Description
Index Displays the CAM index number of the entry.
Destination Displays the destination route of the index.
887