Reference Guide

Example (Private
VLAN)
NOTE: In this example, Line 1 shows community VLAN 200 (in primary VLAN 10) in a
PVLAN. Line 2 shows primary VLAN 10.
FTOS#show arp
Protocol Address Age(min) Hardware Address Interface VLAN
CPU
---------------------------------------------------------------
Internet 5.5.5.1 - 00:01:e8:43:96:5e - Vl 10 pv
200 CP
Internet 5.5.5.10 - 00:01:e8:44:99:55 - Vl
10 CP
Internet 10.1.2.4 1 00:01:e8:d5:9e:e2 Ma 0/0
- CP
Internet 10.10.10.4 1 00:01:e8:d5:9e:e2 Ma 0/0
- CP
Internet 10.16.127.53 1 00:01:e8:d5:9e:e2 Ma 0/0
- CP
Internet 10.16.134.254 20 00:01:e8:d5:9e:e2 Ma 0/0
- CP
Internet 133.33.33.4 1 00:01:e8:d5:9e:e2 Ma 0/0
- CP
Example (cpu cp)
FTOS#sho arp cpu cp
Protocol Address Age(min) Hardware Address Interface VLAN CPU
-----------------------------------------------------------
Internet 10.1.2.206 0 00:a0:80:00:15:b8 Ma 0/0 - CP
Internet 182.16.1.20 0 00:30:19:24:2d:70 Gi 8/0 - CP
Internet 100.10.10.10 0 00:30:19:4f:d3:80 Gi 8/12 - CP
Internet 10.1.2.209 12 00:a0:80:00:12:6c Ma 0/0 - CP
FTOS#
Usage
Information
The following describes the show arp summary command shown in the Example below.
Row Heading Description
Total Entries Lists the total number of ARP entries in the ARP table.
Static Entries Lists the total number of configured or static ARP entries.
Dynamic Entries Lists the total number of learned or dynamic ARP entries.
CPU Lists which CPU the entries are stored on.
Example
(Summary)
#show arp summary
TotalEntries Static Entries Dynamic Entries CPU
----------------------------------------------
83 0 83 CP
FTOS
Related
Commands
ip local-proxy-arp – enables/disables Layer 3 communication in secondary VLANs.
switchport mode private-vlan – sets PVLAN mode of the selected port.
884