Reference Guide

ipv6-address
prefix-length
Enter an IPv6 address (x:x:x:x::x format) and mask (/prefix format) of
the destination subnet. Enter the IPv6 address in the x:x:x:x::x format
followed by the prefix length in the /x format.
The range is /0 to /128.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
forwarding-
router-address
Enter an IP address (dotted decimal format) or an IPv6 address
(x:x:x:x::x format) of a forwarding router.
managementethe
rnet
Enter the keyword managementethernet for the Management
interface on the Primary RPM.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 9.0.0.0 Introduced on the Z9000 and added support for IPv6.
Version 8.3.11.1 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
When a static route (or a protocol route) overlaps with Management static route, the static
route (or a protocol route) is preferred over the Management Static route. Also, Management
static routes and the Management Connected prefix are not reflected in the hardware routing
tables. Separate routing tables are maintained for IPv4 and IPv6 management routes. This
command manages both tables.
Related
Commands
interface ManagementEthernet – configures the Management port on the system (either the
Primary or Standby RPM).
duplex (Management) – sets the mode of the Management interface.
speed (Management interface) – sets the speed for the Management interface.
show arp
Display the ARP table.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show arp [vrf vrf name][interface interface | ip ip-address
[mask] | macaddress mac-address [mac-address mask]] [cpu {cp |
rp1 | rp2}] [static | dynamic] [summary]
881