Reference Guide

Configuration Switched IP Traffic Routed IP Traffic
(IPV4 Only)
Switched Non-IP
Traffic
ip-selection packet-
based and mac
MAC based Packet based: IPV4 MAC based
Related
Commands
ip address – change the algorithm used to distribute traffic on an E-Series chassis.
load-balance hg
Choose the traffic flow parameters to be used in the hash calculation while distributing the traffic across internal higig
links.
Z-Series
Syntax
[no] load-balance hg { ip-selection | ipv6-selection [source-ip
| source-ipv6 | source-port-id | source-module-id | dest-ip |
dest-ipv6 | dest-port-id | dest-module-id | protocol | vlan |
L4-source-port | L4-dest-port ] | mac [source-mac | source-
port-id | source-module-id | dest-mac | dest-port-id | dest-
module-id | vlan | ethertype | source-dest-mac ] | tunnel
[ipv4-over-ipv4 | ipv4-over-gre-ipv4 | mac-in-mac]}
Parameters
{ip-selection|
ipv6-selection
[ source-ip |
source-ipv6 |
source-port-id |
source-module-id
| dest-ip | dest-
ipv6 | dest-port-id
| dest-module-id |
protocol | vlan |
L4-source-port |
L4-dest-port ]
To use IPv4 key fields in hash computation, enter the keyword ip-
selection followed by one of the parameters. To use IPv6 key
fields in hash computation, enter the keyword ipv6-selection
followed by one of the parameters.
• source-ip—Use IPv4 src-ip field in hash calculation.
• source-ipv6—Use IPv6 src-ip field in hash calculation
• source-port-id—Use src-port-id field in hash calculation.
• source-module-id—Use src-module-id field in hash
calculation.
• dest-ip—Use IPv4 dest-ip field in hash calculation.
• dest-ipv6—Use IPv6 dest-ip field in hash calculation
• dest-port-id—Use dest-port-id field in hash calculation.
• dest-module-id—Use dest-module-id field in hash
calculation.
• protocol—Use IPv4 protocol field in hash calculation.
• vlan—Use vlan field in hash calculation.
• L4-source-port—Use IPv4 L4-source-port field in hash
calculation.
• L4-dest-port—Use IPv4 L4-dest-port field in hash calculation.
879