Reference Guide

ip redirects
Enable the interface to send ICMP redirect messages.
E-Series
Syntax
ip redirects
To return to default, use the no ip redirects command.
Defaults Disabled.
Command Modes INTERFACE
Command History
Version 8.1.1.0 Introduced on the E-Series ExaScale.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
This command is available for physical interfaces and port-channel interfaces on the E-Series.
NOTE: This command is not supported on default VLAN (the default vlan-id
command).
ip route
Assign a static route to the switch.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
ip route vrf {vrf instance} destination mask {ip-address |
interface [ip-address]} [distance] [permanent] [tag tag-value]
To delete a specific static route, use the no ip route destination mask
{address | interface [ip-address]} command.
To delete all routes matching a certain route, use the no ip route destination
mask
command.
Parameters
vrf name (OPTIONAL) E-Series Only: Enter the keyword vrf followed by the
VRF Instances name to tie the static route to the VRF instance.
destination Enter the IP address in dotted decimal format of the destination
device.
mask Enter the mask in slash prefix formation (/x) of the destination
device’s IP address.
ip-address Enter the IP address in dotted decimal format of the forwarding
router.
872