Reference Guide

port-channel
number
Enter the keywords port-channel followed by an existing LAG
number. Enter this keyword/variable combination twice, identifying
the two LAGs to be paired.
Defaults none
Command Modes PORT-CHANNEL FAILOVER-GROUP (conf-po-failover-grp)
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the C-Series, E-Series, and S-Series.
Related
Commands
port-channel failover-group – accesses PORT-CHANNEL FAILOVER-GROUP mode to configure
a LAG failover group.
show interfaces port-channel – displays information on configured Port Channel groups.
interface port-channel
Create a Port Channel interface, which is a link aggregation group (LAG) containing up to 16 physical interfaces on the
E-Series and eight physical interfaces on C-Series and S-Series.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
interface port-channel channel-number
To delete a Port Channel, use the no interface port-channel channel-number
command.
Parameters
channel-number For a Port Channel interface, enter the keywords port-channel
followed by a number. For the C-Series, S-Series, and Z9000, the
range is 1 to 128. For the E-Series, the range is 1 to 255 for TeraScale
and 1 to 512 for ExaScale.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 8.3.12.0 Introduced on S4810.
Version 8.3.11.1 Introduced on Z9000.
Version 8.1.1.0 Introduced on E-Series ExaScale.
Version 7.6.1.0 Introduced on S-Series.
Version 7.5.1.0 Introduced on C-Series.
pre-Version
6.2.1.0
Introduced on E-Series.
832