Reference Guide

Related
Commands
interface – configures a physical interface on the switch.
show ip interface – displays Layer 3 information about the interfaces.
show interfaces – displays information on a specific physical interface or virtual interface.
show inventory (C-Series and E-Series) – displays the chassis type, components (including
media), FTOS version including hardware identification numbers and configured protocols.
show inventory (S-Series) – displays the S-Series switch type, components (including media),
FTOS version including hardware identification numbers and configured protocols.
show range
Display all interfaces configured using the interface range command.
C-Series, E-Series, S-Series, Z-Series
Syntax
show range
Command Modes INTERFACE RANGE (config-if-range)
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.2.1.0 Added support for 4093 VLANs on E-Series ExaScale.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.1.1.0 Introduced.
Example
FTOS(conf-if-range-so-2/0-1,fa-0/0)#show range
interface sonet 2/0 - 1
interface fastethernet 0/0
FTOS(conf-if-range-so-2/0-1,fa-0/0)#
Related
Commands
interface – configures a physical interface on the switch.
show ip interface – displays Layer 3 information about the interfaces.
show interfaces – displays information on a specific physical interface or virtual interface.
show running-config ecmp-group
Display interfaces, LAG, or LAG link bundles being monitored for uneven traffic distribution using the ecmp-group
monitoring enable command. The ECMP group could have a LAG or a list of 10G/40 interfaces (not just LAG link-
bundles).
S4810
Syntax
show running-config ecmp-group
Defaults Disabled.
823