Reference Guide

Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Usage
Information
The Example below shows a line card that has an XFP interface. The type, medium,
wavelength, and receive power details are displayed. When a device that is not certified by
Dell Force10 is inserted, it might work, but its details might not be readable by FTOS and not
displayed here.
Example
FTOS#show interfaces linecard 0
TenGigabitEthernet 0/0 is down, line protocol is down
Hardware is Force10Eth, address is 00:01:e8:51:b2:d4
Current address is 00:01:e8:51:b2:d4
Pluggable media present, XFP type is 10GBASE-SR
Medium is MultiRate, Wavelength is 850.00nm
XFP receive power reading is -2.3538
Interface index is 33883138
Internet address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 10000 Mbit
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 20:16:29
Queueing strategy: fifo
Input Statistics:
0 packets, 0 bytes
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte
pkts
0 Multicasts, 0 Broadcasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
0 packets, 0 bytes, 0 underruns
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
--More--
Related
Commands
show interfaces – displays information on a specific physical interface or virtual interface.
show interfaces phy
Display auto-negotiation and link partner information.
C-Series, E-Series, S-Series, Z-Series
Syntax
show interfaces gigabitethernet slot/port phy
Parameters
gigabitethernet Enter the keyword gigabitethernet followed by the slot/port
information.
Command Modes
• EXEC
• EXEC Privilege
811