Reference Guide

NOTE: Because polling occurs every 15 seconds, the number of
seconds designated here will round to the multiple of 15 seconds
lower than the entered value. For example, if 44 seconds is
designated, it will round to 30; 45 to 59 seconds will round to 45,
and so forth.
Defaults 299 seconds
Command Modes INTERFACE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.1.1.0 Introduced
Usage
Information
The output of the show interfaces command displays the configured rate interval, along
with the collected traffic data.
Related
Commands
show interfaces – displays information on physical and virtual interfaces.
show config
Display the interface configuration.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show config
Command Modes INTERFACE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.0
Introduced on the E-Series.
Example
FTOS(conf-if)#show conf
!
interface GigabitEthernet 1/7
no ip address
switchport
797