Reference Guide

Command Modes CONFIGURATION
Command History
Version 9.1.(0.0) Introduced on the S4810; added support for OpenFlow.
Version 8.3.11.1 Introduced on the Z9000.
Usage
Information
For more information about VLANs and the commands to configure them, refer to the Virtual
LAN (VLAN) Commands section of the Layer 2 chapter.
FTP, TFTP, and SNMP operations are not supported on a VLAN. MAC ACLs are not supported in
VLANs. IP ACLs are supported. For more information, refer to the Access Control Lists (ACL)
chapter.
The following features are not supported on VLANs associated with an OpenFlow instance:
• IPv4
• IPv6
• MTU
If OpenFlow VLANs are configured on the switch, spanning-tree protocols cannot be enabled
simultaneously.
Example (Single
Range)
FTOS(conf)#int vlan 3
FTOS(conf-if-vl-3)#
Related
Commands
interface – configures a physical interface.
interface loopback – configures a loopback interface.
interface null – configures a null interface.
interface port-channel – configures a port channel group.
show vlan – displays the current VLAN configuration on the switch.
shutdown – disables/enables the VLAN.
tagged – adds a Layer 2 interface to a VLAN as a tagged interface.
untagged – adds a Layer 2 interface to a VLAN as an untagged interface.
openflow of-instance — creates or modifies an OpenFlow instance.
ipg (Gigabit Ethernet interfaces)
Set the inter-packet gap (IPG) to 8 bytes for traffic on a Gigabit Ethernet interface.
E-Series
Syntax
ipg 8
To return to the default setting, use the no ipg command.
Parameters
8 Enter the keyword 8 to set the IPG to 8 bytes.
Defaults 12 bytes
Command Mode INTERFACE
786