Reference Guide

Defaults Disabled.
Command Modes EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
IGMP commands accept only non-VLAN interfaces—specifying VLAN does not yield results.
This command displays packets for IGMP and IGMP snooping.
ip igmp access-group
Use this feature to specify access control for packets.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
ip igmp access-group access-list
To remove the feature, use the no ip igmp access-group access-list command.
Parameters
access-list Enter the name of the extended ACL (16 characters maximum).
Defaults Not configured
Command Modes INTERFACE (conf-if- interface-slot/port )
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the C-Series and S-Series.
Version 7.6.1.0 Introduced on E-Series.
Usage
Information
The access list accepted is an extended ACL. Use this feature to block IGMP reports from
hosts, on a per-interface basis based on the group address and source address that you
specify in the access list.
ip igmp group-join-limit
Use this feature to limit the number of IGMP groups that can be joined in a second.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
ip igmp group-join-limit number
751