Reference Guide

Related
Commands
process restartable
show redundancy
Display the current redundancy configuration.
C-Series, E-Series, S4810
Syntax
show redundancy
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.12.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced on the E-Series.
Usage
Information
The following describes the show redundancy command shown in the Example below.
Field Description
RPM Status Displays the following information:
• Slot number of the RPM.
• Whether the RPM is Primary or Standby.
• The state of the RPM: Active, Standby, Booting, or Offline.
• Whether the link to the second RPM is up or down.
PEER RPM Status Displays the state of the second RPM, if present
RPM Redundancy
Configuration
Displays the following information:
• which RPM is the preferred Primary on next boot (the
redundancy primary command)
• the data sync method configured (the redundancy
synchronize
command)
• the failover type (you cannot change this type; it is software-
dependent). Hot Failover means that the running
configuration and routing table are applied on secondary
RPM. Fast Failover means that the running configuration is
not applied on the secondary RPM until failover occurs, and
the routing table on line cards is cleared during failover.
• the status of auto booting the RPM (the redundancy
disable-auto-reboot
command)
744